No products
Top sellers
-
Formsand, spefol
Molding sand is a fine-grained mineral mixture that is permeated with an...
25,88 € -
Refractory plaster
Refractory plaster to cast bronze, brass, glass (fusing, thermoformage)...
14,64 € -
Plaster bandage 12.5cm x460cm
Cut the desired length of the Plaster of Paris. Let it soak in water...
2,78 € -
Doex, phosphorus copper
Phosphorus copper cartridge used to deoxidize and fluidify the bronze...
8,40 € -
-
-
Modelling and casting wax AS135
Modelling and casting waxCan be cast in silicone moldMelting point...
15,33 € -
Patina 516/3, for bronze, brown-black
Patina ready-to-use. Apply with a brush on the bronze, copper,...
5,34 € -
-
Patina 77/2, for bronze, green antique
Patina ready-to-use. Apply with a brush on the bronze, copper,...
5,69 €
Categories
Manufacturers
No manufacturer
Suppliers
No supplier
Top sellers
-
-
Solder Sn97Cu3, round rod
Solder 97% stain, 3% copper, round rod, for tiffany Given the fluctuation of stock prices, the prices given are for the quantities of stock. If an order should be placed out of stock, an estimate with updated prices will be given to you.
7,26 € -
Gum Rosin
Colophony or pine resin is a vegetable resin that is extracted from the resin of conifer species
5,72 € -
-
-
-
-
Baldiez
Airbrush it straight into your Platsil Gel silicone mould and apply your Platsil Gel (and Deadener) mixture over the top. Let it set, dust with talc to remove. Apply piece by sponging Platsil Gel to the face as normal, and watch your edges desolve with IPA (alcohol isopropalic).The Super Baldiez is stronger, clearer and gives you slightly more time to...
13,61 € -
Curing agent mek-peroxyde
To use with polyester 55/8, 65/15, 26/71Add curing agent 0.5 to 2% to polyester
3,63 € -
-
PST4, release wax
Release agent. Is applied with a brush or a spray and leaves an invisible film after drying. One layer can serve several times. Recommended as release agent for silicones on silicones.
7,38 € -
Acrylresin, plaster adjuvant
Plasticrète is a water-based acrylic resin that forms a solid mass with the special hardener. Shore hardness A: 82-86 Demold after: 4-15 hrs at 25°C Potlife: 22-30 min. Frost resistance: -18 + 30°C Mixing ratio A: B by weight: 50: 100.
23,00 €
